welcome: please sign in
location: Diff for "RWmixer"
Differences between revisions 6 and 7
Revision 6 as of 2020-03-15 07:22:29
Size: 803
Editor: guest
Comment:
Revision 7 as of 2020-03-15 07:22:43
Size: 812
Editor: guest
Comment:
Deletions are marked like this. Additions are marked like this.
Line 5: Line 5:
The mixer section is a pretty straightforward summing amplifier followed by a differential output driver for the headphone output. The synth output is sent to a seperate jack before the mix, and is only included in the mix if no plug is inserted. There is a mute circuit on the outputs which is controlled by both the powersupply board and the microcontroller. This seems a bit redundant, as the microcontroller also controls the the analog rail generation, and i cant see why you would want to un-mute the output before turning on the analog power supply. Between the mixer and output driver is the "howl" distortion circuit. This has asymmetric clipping, a low-pass filter, and a <6dB/octave slope high-pass filter. The mixer section is a pretty straightforward summing amplifier followed by a differential output driver for the headphone output. The synth output is sent to a seperate jack before the mix, and is only included in the mix if no plug is inserted. There is a mute circuit on the outputs which is controlled by both the powersupply board and the microcontroller. This seems a bit redundant, as the microcontroller also controls the the analog rail generation, and i cant see why you would want to un-mute the output before turning on the analog power supply. Between the mixer and output driver is the "howl" distortion circuit. This has asymmetric clipping, a low-pass filter, and a less than 6dB/octave slope high-pass filter.

Rhythm Wolf Mixer Section

Schematic

The mixer section is a pretty straightforward summing amplifier followed by a differential output driver for the headphone output. The synth output is sent to a seperate jack before the mix, and is only included in the mix if no plug is inserted. There is a mute circuit on the outputs which is controlled by both the powersupply board and the microcontroller. This seems a bit redundant, as the microcontroller also controls the the analog rail generation, and i cant see why you would want to un-mute the output before turning on the analog power supply. Between the mixer and output driver is the "howl" distortion circuit. This has asymmetric clipping, a low-pass filter, and a less than 6dB/octave slope high-pass filter.

RWmixer (last edited 2021-04-28 03:58:35 by guest)