|
← Revision 4 as of 2013-01-18 05:39:21
Size: 1084
Comment:
|
← Revision 5 as of 2013-01-18 05:42:03 →
Size: 1395
Comment:
|
| Deletions are marked like this. | Additions are marked like this. |
| Line 12: | Line 12: |
|
==== Arduino library ==== The following is an Arduino library (just a first rev, nothing fancy). Download the zipped file, and uncompress it. The entire folder needs to be placed in you ''libraries'' folder in your user directory. If you are not sure where this is, check out our description under the |
Minimalist Arduino DSP
About Minimalist Arduino DSP
This is the the most basic setup for doing decent quality audio effects with an Arduino. The system is based upon both our PWM tutorial and our ATmega ADC tutorial. The basic setup is a 10 bit value read in from ADC0, and played out via a 16 bit, Dual PWM on pins 9 and 10. there are 2 buttons, on pins 2 and 3, which can be used to modify parameters. The reason for buttons and not knobs, is that the ADC is already completely consumed with the analog audio signal coming in. This is a more focused version of our basic Arduino PWM setup, targetted at effects pedals.
Hardware setup
The follow schematic is the basic version to get started. There will eventually be a better version with a dual opamp, and gain, mix, feedback, and level knobs. But that might take a bit to finish.
Arduino library
The following is an Arduino library (just a first rev, nothing fancy). Download the zipped file, and uncompress it. The entire folder needs to be placed in you libraries folder in your user directory. If you are not sure where this is, check out our description under the